Ufp/Dexter Disc Brake Kit 8K 8-Lug Zinc Rotor & Aluminum Caliper (One Wheel)

UFP by Dexter 8000 lb 12" 6 on 5.5" Zinc+ Rotor with Aluminum Caliper Kit. 

NOTE:
Mounting yoke on 8,000 lb caliper is specifically designed to mount on Dexter Axle 8,000 lb brake flange.

Kit Includes:

1 - 8-Lug Zinc+ Plated Rotor
1 - Aluminum Caliper with Aluminun piston
1 - Set Brake Pads (w/Dacromet coated brake pad plate and anchor yoke)
1 - Brass Banjo Fitting
1 - Banjo Bolt (stainless steel)
1 - Bleeder Screw (stainless steel)
2 - Copper Washers
2 - Caliper Mounting Bolts (Zinc plated)
1 - Seal
1 - Inner Bearing 25580
1 - Outer Bearing 02475
1 - Stainless Steel Bearing Protector w/Bra
8 - Cone Lug Nuts (Zinc Plated)

Slider pins, pad guides, and anti-rattle springs are all stainless steel.

Zinc+ = Zinc plated with top coat sealant that provides five times the corrosion protectant when applied over zinc plating.

Additional Features

No left or right hand calipers. (Fittings are shipped loose allowing the installer the ability to use caliper on either side. When mounting calipers, the bleeder screw postion should always be on top to allow proper bleeding.)

Ventilated rotors for temperature regulation to reduce brake pad deterioration, excessive wear and warping

Non-metallic, non-asbestos, organic pad materials to eliminate corrosion.

Disc brake caliper to be used with 8-lug 16" wheel and larger

Inlet/outlet port positions decrease amount of air in system through a large range of torsion arm trailing angles

Braking forces are transferred to the yoke/anchor bracket and not the caliper slider pins